Glow-worm Clearly Heat Recovery - Manual (Page 15)

www.glow-worm.co.uk
15
User Controls
Programming of the Clock Timer
With the programming button you can change the times
for the timer mode. With activated timer function, Atmosorb
will switch between the first and the second stage (time-
controlled).
● Outside the time window: Stage 1 =
night mode
● Within the time window: Stage 2 = day mode
It is possible to set up to three different switching-on and -off
times (time windows) for each day of the week. In the display
of the remote control these time windows are shown as: H1,
H2 or H3.
You can combine individual days in groups or a
week block. The following groups are possible:
MO - FR; SA - SU; MO - SU.
The operating times are set as follows, refer to diagram 4 for
the layout of the control panel:
● From the basic display, press the "mode" button several
times until a flashing H1 is displayed.
● Select the time window, H1, H2 or H3 using the - and +
buttons.
● Press the "prog" button to select day or a week
block, press the - or + to change the flashing value.
● Press the "prog" button again to show the starting time,
press the - or + to change the flashing value. Do this for
hours then minutes. Press "prog" to change from hours to
minutes.
● Press the "prog" button again to show the end time,
press the - or + to change the flashing value.
● Terminate programming of the operating time by pressing
the "mode" button.
Factory-set operating times are:
Time window Day of the
week/Block
Start time End time
H1 MO-FR 6:00 22:00
H1 SA 7:30 22:30
H1 SU 7:30 22:00
NOTE: Within the programming level you can navigate with
the "mode" and - or + push buttons.
With the "mode" : you can change within one programming
level from one menu item to the other.
Push the mode button several times in
order to reach the desired function. The
parameter you want to change is flashing
and an indication arrow appears.
With the - or + : you can change the flashing value.