Glow-worm Clearly Heat Pumps 5kW - Manual (Page 15)

0020096879_01 - 06/10 - Glow-worm
- 13 -
INSTALLATION
b
Warning! Do not lean the appliance more than
45° during transportation as this may damage
the refrigeration circuit which could lead to a
complete system failure.
i We recommend that you move the appliance with a
trolley or with suitable handling equipment.
If you move the appliance with a two-wheeled trolley, respect the
following regulations:
• Only lift the appliance from the back.
• Attach the appliance to the two-wheeled trolley with a strap.
• Protect surfaces in contact with the trolley to avoid scratching
or damaging the appliance.
• Use a sufficiently solid ramp to lower the appliance from the
pallet.
• Move the appliance to the installation site.
7.5 Positioning the appliance
b Warning! The heat pump must be installed with
the anti-vibration pads supplied.
i
The anti-vibration pads are used to raise the unit,
limit the transmission of vibrations and to facilitate
the discharge of condensates.
i
With regards to the Manual Handling Operations,
1992 Regulations, the following lift operation
exceeds the recommended weight for a one man lift.
1
2 3
Key
1 Anti-vibration pads
2 Nut
3 Washer
• Place the heat pump on the 4 anti-vibration pads (1).
• Secure the heat pump to the anti-vibration pads (1) using
washers (3) and nuts (2).
8 Opening the appliance
B
C
A
A
A
A
2
2
3
1
Key
1 Handle
2 Attachment screws
3 Side panel
• Remove the attachment screw (2).
• Slide the side panel (3) down and pull it toward you using the
handle (1).