Glow-worm Micron 70FF - Manual (Page 12)

12 2000225229C
Seal the joint with the tape provided.
If the flue system requires the addition of flue extension kits,
drill, seal and secure them with the self tapping screw and tape
provided. The completed flue system must not exceed 3
metres, see relevant part of diagram 4.1.
NOTE: Should any one of the flue sections require cutting to
obtain desired flue system length, cut the 1 metre extension kit
at the end opposite the expanded end.
Make sure to cut square and remove any burrs.
If the boiler is not to be fitted for some time cover the hole in the
wall.
NOTE: If a horizontal flue extension is required it must be used
in conjunction with the standard flue, see diagram 4.1.
IMPORTANT: When using the standard flue kit (either rear
outlet or top outlet fixing) or Easyfit, the terminal restrictor
must be fitted. This is not fitted for any other flue type/
arrangement, extension kits etc.
NOTE: There are three restrictors in the loose items pack,
use the one stamped "D" for the Micron 70FF.
Take the terminal restrictor and position the clamping bracket
making sure the clamping bracket nib protrudes in the slot of the
terminal restrictor and secure with locking screw, but do not
tighten, see diagram 4.6.
Engage the terminal restrictor on the flue terminal by hooking
it over the terminal end and engaging the clamping bracket
behind the inner ring of the terminal securing it by tightening the
locking screw, see diagram 4.6
4.7 Internal Access Flue
If access to the outside wall is not practical, the flue system can
be installed from inside. Use of the optional wall liner kit is
required.
4.8 Rear Flue Fixing
Fit the self adhesive foam seal provided in the flue pack around
the air duct at the position shown in diagram 4.1.
Make sure that the ductings do not slope down towards the
boiler.
Make good around the flue outside after installation of boiler.
IMPORTANT: If the wall liner kit is used, the self adhesive foam
seal included must be used in place of the one supplied with the
flue pack, see diagram 4.5 for position of self adhesive seal.
4.9 Top, Side Flue Fixing
Make sure that the ductings do not slope down towards the
boiler.
Make good the area around the flue, inside and outside, after
installation of the boiler.
IMPORTANT: If the wall liner kit is used, the self adhesive foam
seal included must be used in place of the one supplied with the
flue pack, see diagram 4.5 for position of self adhesive seal.
4.10 Flue Positioning
Push the flue assembly into the hole such that it is within the wall
and does not stick out into the room. Do not push the flue
assembly too far into the hole as it has to be pulled back into the
boiler and secured.
4 Flue and Appliance Preparation
Diagram 4.5
FOAM SEAL
FOAM SEAL
WALL THICKNESS-
OVER 300mm
15mm
WALL THICKNESS-
UP TO 300mm
Q-35mm
Q
Q
7331
Diagram 4.6
7323
RESTRICTOR
CLAMPING
BRACKET
CLAMPING
BRACKET NIB
FLUE
TERMINAL
LOCKING
SCREW
TERMINAL RESTRICTOR
SHOWN FITTED
7332
WITH WALL LINER KIT ONLY
STANDARD 510mm REAR AND
STANDARD 570mm TOP FLUE ONLY
EASYFIT 570mm or less