GoDEX RT700iW series - Manual (Page 40)

36
3
Setting and Control for Operation Panel
3.7 Error Alerts
033
In the event of a problem that prevents normal functioning of the printer, you will see an error message on LCD
screen and hear some beep signals. Please refer to below table for the error alerts.
RT700i
FEED BUTTON
DIRECTION KEY
OPERATION PANEL
POWER BUTTON
LCD SCREEN
Operation Panel
Status
Type Beeps Description Solution
Print Head Error 2 x 4 beeps The printing mechanism is not
correctly closed.
Open the print mechanism and
close it again.
Print Head Error None
High temperature at the print
head.
Once the print head has cooled
down, the printer switches to
standby mode.
Media Error 2 x 3 beeps
No ribbon is installed and the
printer displays an error.
Make sure that the printer is set to
direct thermal printing mode.
The ribbon is finished or the label
supply hub is not moving.
Replace the ribbon roll.
Media Error 2 x 2 beeps
No paper is detected.
Make sure that the label sensor is
positioned correctly. If the sensor
still does not detect the paper,
run the auto-detection function
again.
Paper is finished. Replace the label roll.
Printer feed problem.
Possible reasons: the print medium
has become trapped around the
rubber roll; the sensor cannot
detect a gap or black mark
between the labels; there is no
paper. Please reset the sensor.
Printhead up (Open)
Check Ribbon
Check Media