GoDEX RT700iW series - Manual (Page 44)

3
Printer Setting and Control
3.9 Dump Mode Begin
For make sure provide us correct information for check what commands sentfrom the PC or software, please following below
steps,
STEP 1, Let the printer enter Dump Mode
For Desktop printer (RT200i / RT700i series, with LCD)
Just press and hold the key until LCD Display shows “DUMP MODE ”, then release the key.
STEP 2. Make sure pinter ready for print a label
STEP 3. Send a label or commands which met problem to the printer
STEP 4. Printer will print out a label with letters and numbers, please take a picture on them and send us by email.
To cancel (get out of) the Dump Mode, please press the FEED key, and then the printer will
automatically print “OUT OF DUMP MODE.” This indicates that the printer is back to the standby mode.
40