GoDEX RT860i - Manual (Page 37)

33
3
Printer Setting and Control
Label Calibration
The printer can automatically detect and store label height.
That means the host computer does not need to transmit the label height to the printer.
3.4 Label Calibration and Self Test
Self Test
Self-test function lets you check whether the printer is functioning normally.
Here is how you run the label size calibration and self test.
1. Check that the label stock is loaded correctly.
2. urn off the printer and pressing the FEED button.
3. Turn the printer on again, keeping the FEED button pressed. When the LED starts to flash red, release the FEED
button. The printer will now measure the label stock and store the label height.
4. Once the printer has successfully measured the label stock, it will print a self-test label.
The contents of a self-test printout are listed below.
Model & Version
USB ID setting
Serial port setting
MAC address of Ethernet port
IP address setting
Gateway setting
Sub-Mask setting
Port status
(The default value is 1, which means that all ports open)
Number of forms
Number of graphics
Number of fonts
Number of Asian fonts
Number of Databases
Number of Scalable fonts
Free memory size
Speed, Density, Ref. Point, Print direction
Label width, Form length, Stop position
Cutter, Label Dispenser, Mode
Sensor Setting
Code Page
RT860i VX.XXX
USB S/N:12345678
Serial port:96,N,8,1
MAC Addr:xx-xx-xx-xx-xx-xx
IP xxx.xxx.xxx.xxx (DHCP_10MF)
Gateway xxx.xxx.xxx.xxx
Sub-Mask xxx.xxx.xxx.xxx
PORT State L S E U B
1 1 1 1 1
##########################
0000 FORM(S) IN MEMORY
0000 GRAPHIC(S) IN MEMORY
000 FONT(S) IN MEMORY
000 ASIAN FONT(S) IN MEMORY
000 DATABASE(S) IN MEMORY
000 TTF(S) IN MEMORY
63980 KB FREE MEMORY
^S3 ^H8 ^R000 ~R200 ~Q+0
^W102 ^Q100,3 ^E16
Option:^D0 ^O0 ^AT
Ref.:0.4 2.8 1.4 [2.4_8]
Code Page:850