GoDEX EZDT4 User Manual
Page 20
Z-DT-4
E
EZ-DT-2
5.
Turn the
printer
around and
tighten
sc
o
rews t fix
the Cutter in
location.
5.
Loose the
screw of
Bottom
Case Cover
and open it.
6.
Unlock the
Bottom Case
Cover to see
the main
of
r.
board
printe
6.
Tighten the
screws to
fix the
Cutter in
location.
7.
Plug the connector into the
main board.
【Note】
Before plugging the connector
into socket, please check the
pin first.
8.
Lock the Bottom Case
Cover. (
For EZ-DT-2,
please tighten the screw of
Bottom Case Cover)
9.
Turn the printer back to
proceed to the label
installation.
10.
o
It is n
se
label-inside paper when printing
with cutter module.
Follow the instruction on
Chapter 2-1 to install the
label.
【N te】
ot suggested to u
11. Feed the label through the
Cutter and press the
FEED key to complete the
installation.
【Suggestion】
When printing with cutter
module, it is suggested to set
the stop position (^E) to 33 (for
DT-4) and 29 (for DT-2).
EZ-DT-2/EZ-DT-4 User’s Manual
19