GoDEX EZDT4 - Manual (Page 26)

4. Printer Setting
4
After pre feed the media (according to media type) to the
s ith continuous media, pressing the FEED key will feed
the media out printing with labels, the printer will feed one label each
time the FEED key is pressed. If the label is not sent out in a correct position, please proceed
with the Auto Sensing (see next section).
4
*N : ware version G3.000 or after.
Press an r on the printer. Wait for the LED light flashing red and
then release the FEED key, the printer will enter into Auto Sensing Mode to do the calibration. A
Self-Test page will be printed out automatically after the calibration is completed. Below are the
sequence and the description of two modes:
us Description
-1. FEED Key
ssing the FEED key, printer will
pecified stop position. When printing w
to a certain length. When
-2. LED Status
ote below descriptions are only applied on firm
d hold the FEED key then powe
LED Light Beep Stat
Green X Standby Mode Normal status
Press and hold the FEED Key then power on the printer.
Red (Flash) 3 Auto Sensing Mode
Printers are currently in Auto
Sensing Mode. The calibration will
be performed and a Self-Test page
will be printed out to show the
configurations of printer. For more
detail about Auto Sensing Mode,
please refer to next section. For the
descriptions of Self-Test page
please refer to page 26.
4-3. Auto Sensing
Printer can automatically detect the label and store the result of detecting. By doing this, the
printer will calibrate the printing position of the label and the user can do printing without setting
the label length. To perform the Auto Sensing, please do as follows:
1.
Check if the label is correctly loaded on the printer.
2 P ED key.
3. P ter while still holding the FEED key. Keep holding the FEED key, wait for
the LED light turn to flash red and then release the FEED key. Printer will automatically
the label and record it.
4 fter Auto Sensing is completed and the printer goes
. ower off the printer, press and hold the FE
ower on the prin
detect
. A Self-Test page will be printed out a
back to standby mode.
EZ-DT-2/EZ-DT-4 User’s Manual
25