Character replacements, Character replacements –8, Character to replace – GoDEX GS220 User Manual
Page 47: Replacement character, No replacement
Advertising
7–8
Character Replacements
To replace a character:
1. Scan
the
enter/exit configuration mode bar code (on page 1–1).
2. Scan
the
character to replace code (shown below).
3. Scan the ASCII code byte value of the character you wish to replace.
Refer to the ASCII Reference Table in the Code Byte Usage section of
this manual.
4. Scan
the
replacement character bar code (shown below).
5. Scan the ASCII code byte value of the replacement character.
6. Scan
the
enter/exit configuration mode bar code (on page 1–1).
³
9
3
8
6
0
0
~ Character to Replace
³
9
3
8
7
0
0
~ Replacement Character
³
8
3
8
6
0
0
No Replacement
Advertising