Grandview CB-UM(Motorized Floor-Up Series) - Manual (Page 3)

2 5
3. Connect the power line together with the screen out case by the plug of back side. (Figure 5-6)
(Please take notice the voltage and make sure it will be safety)
First, open the package and take out all the parts from the box, make sure all the parts are
available in the box and operate it according the manual. to
Instruction
1. Put the screen on the flat ground or on the flat table. ( Figure 1)
2. Push forward the button which lies on left side of the case slightly to open the multifunction box,take
out the power line and push the remote control slightly and let it come out of the case automatic.
( Figure 2-4)
Figure 1
Figure 2 Figure 3 Figure 4
Figure 5 Figure 6
1. To ensure safety, don't approach or touch the multifunction box on the right side of screen outer case
after you connect the screen with the power.
2. Don't put your finger inside of the case when you retract the screen fabric back to the case.
3. Don't hang anything or put any goods on the top of the screen case when your screen is ready to work.
4. Dusty or scratch on the screen will damage the image of projection, Please pay much attention for the
following points:
a. do not touch the screen surface by hand.
b. do not drawing on the screen surface.
c. do not scrape or scratch the screen, doing so with hard materials can cause damage.
d. Never use chemicals to wash the screen surface.
5. Make sure there isn't any gnat or things before you retract the screen back to the case.
6. The motor will stop working after 4 minutes using according to the self-protect purpose, When it happen,
you had to wait for 2 minute after the temperature of the motor come down.
7. There is no need for you to add the lube to the motor. And the motor is already in the right position in the
production. Do not adjust the motor by yourself. Please call the specialty to help you on this.
Notice
Motor adjusting slot