Grandview CB-UM(Motorized Floor-Up Series) - Manual (Page 4)

3 4
1. Built-in IR control Figure 7
2. IR receiver with cable control Figure 8
3. Switch control Figure 9
Control method Instructions
The motorized screen can be controlled by built-in IR, IR receiver with cable & switch control.
When the built-in IR receiver works without anything
blocking, you can control the screen up, down, or stop.
You can also connect the IR receiver with cable and
extend the receiver once for special condition.
If you cannot control the screen by IR or for any external
reasons, you can press the switch control button to
control the screen instead.
Figure 7
Figure 8
Figure 9
Infrared receiving window
Infrared jack
Switch control button
How to install the battery:
1.Turn the controller around, push to open the cover as
guide arrow.
2.Put the battery in according the guide of cathode and
anode.
3.Close the cover.
UP
DOWN
STOP
LED remote controller
Controller button instruction
1.To raise screen press "UP .
2.To hold screen at desired position press STOP .
3.To lower screen press DOWN .
Manual Control Instructions
If you don't use the Infrared controller , the screen canbe controlled directly
through the button on the receiver.
Motor Direction-Conversion Switch (SW1) Instruction
When using controller or manual control to control the screen , if the screen
can't work properly (i .e. Press UP but screen goes down. While press DOWN
screen goes up.), you need to press SW1(figure 2) to make it work normally .
1.
2 will
3 will if
4
5
6
7
8.
9.
"
" "
" "
" " " "
Caution:
The shortest distance between receiver and controller is 0.5 meter.
.Controller work within 30 degree away horizontally from the c enter of r eceiver
point within 8 meters from the screen .
.The controller not work the signal was coveredby something.
.Keep the controller far away from high temperature and humid situation.
.Please change the battery when the signal is weak.
.Please take the battery out if the controller was not being used for long time.
.Please choose the same type battery as original supplied.
If the receiver won't be used in a long time, please cut
off the electricity or take off the plug.
When pressing the button to control , you will hear da-da from the
receiver, which means it isworking normally.
4. To raise the screen little at your desired position press MICRO-UP
5. To lower the screen little at your desired position press MICRO-DOWN
Electricity will be cut off from the receiever 3 minutes after use , but it will
remain on stand-by.
1GD IRAn
MICRO-UP MICRO-DOWN