Grandview GPCP-D - Manual

Cautious
Warnings For safety, the minimum of ceiling must be 20Kg weight
Caution Please do not incline the projector the extremely.
Please do not take apart the accessories of projector
ceiling mount. Do not
take apart
Weight
The maximum weight of installation bracket is 20Kg
(note: the installation bracket's maximum weight of GPCP-D90150 is 15kg)
Please read before using
Thank you for purchasing our products. Please read the instruction
manual carefully in order to ensure this projector lift is suitable for your
projection equipment.
Instruction Manual
GRANDVIEW REPRODUCING GENUINE COLORS
Projector Wall Mount
Applicable Model
GPCP-D4060
GPCP-D6090
GPCP-D90150
Grandview Crystal
Screen Canada Ltd.
#11- 3751 North Fraser Way,
Marine Way Business Centre,
Burnaby, BC, Canada V5J 5G4
Tel: 1-604-412-9777
Fax: 1-604-412-9796
Website: www.grandviewscreen.ca
Guangzhou Grandview
Crystal Screen Co., Ltd.
P.O. 511400 Federal Ind. Zone No. 363,
Yushan West Road,Shiqiao, Panyu
District, Guangzhou, Guangdong, China
Tel: +8620-8489-9499
Fax: +8620-8480-3343
Website: www.grandviewscreen.com
Details of installation
Height and length adjustment
1.Loosen the positioning screws of low board (2-2), the height of GPCP
Main Bar Overview can be adjusted (the maximum height: 45mm) as
figure 11.
2.Loosen the positioning screws of main bar (1-4), the length of
subsidiary bar (1-3) can be adjusted (check about the data of scope for
installation) as figure 12.
3.Loosen the positioning screws of installation board (1-5), the height
of installation board (1-5) can be adjusted (the maximum height: 30mm)
as figure 13.
figure 11 figure 12 figure 13
Installation of main bar
1.Firstly, please confirm how many installation holes the projector has?
3 or 4.
2.If there are 3 holes, the installation arms (4-3) need to be taken apart
from Installation bracket firstly. Connect 3 installation arms(4-3) to the
projector, and then connect the installation arms (4-3) to the installation
base (4-6) However,the installation base needs to be the center of
projector. Figure 16
3.Connect the installation arms to the projector conversely if the
distance of installation holes is less than 120mm. Connect the
installation arms (4-3) to the installation base (4-6) via sliding
installation button (4-5) as figure 17
4.Rotate the adjustable screw (4-4) for adjusting the height of instllation
arms (4-2) if the installation holes are not at the same level as figure 18.
5.The front or back of adjuster must be parallel to the surface of
projector as figure 19.
Angle Adjustment
1.Loosen the positioning screws (front and back) for adjusting the
angle, and then rotate the screwdriver for fine turning to the required
angle as figure 14.
2.Loosen the positioning screws (left and right) for adjusting the angle,
and then rotate the screwdriver for fine turning to the required angle as
figure 15.
figure 14
figure 15
vertical tilt:±15°
The angle of
horizontal tilt:±5°
The nagle of
figure 19
The front or back of
adjuster must be
parallel to the surface
of projector
figure 17 figure 18
figure 16
Scope of
adjustment:10mm