Grandview GPCQ-X User Manual
Instruction manual, Projector lift, Cautious
Instruction Manual
GRANDVIEW REPRODUCING GENUINE COLORS
Projector Lift
Applicable Model
GPCQ-X
Please read before using
Thank you for purchasing our
products. Please read the
instruction manual carefully
in order to ensure this
projector lift is suitable for
your projection equipment.
Cautious
Details of installation
Installation of main bar
1.Firstly, please confirm how many installation holes the projector has?
3 or 4
2.If there are 3 holes, the installation arms need to be taken apart from
Installation bracket firstly. Connect 3 installation arms to the projector,
and then connect the installation arms to the installation base However,
the installation base needs to be the center of projector. Figure 10.
3.Connect the installation arms to the projector conversely if the
distance of installation holes is less than 120mm. Connect the
installation arms to the installation base via sliding installation button as
figure 11
4.Rotate the adjustable screw for adjusting the height of instllation arms
if the installation holes are not at the same level as figure 12.
5.The front or back of adjuster must be parallel to the surface of
projector as figure 13.
Grandview Crystal
Screen Canada Ltd.
#11- 3751 North Fraser Way,
Marine Way Business Centre,
Burnaby, BC, Canada V5J 5G4
Tel: 1-604-412-9777
Fax: 1-604-412-9796
Website: www.grandviewscreen.ca
Guangzhou Grandview
Crystal Screen Co., Ltd.
P.O. 511400 Federal Ind. Zone No. 363,
Yushan West Road,Shiqiao, Panyu
District, Guangzhou, Guangdong, China
Tel: +8620-8489-9499
Fax: +8620-8480-3343
Website: www.grandviewscreen.com
Warnings
For safety, the minimum
of ceiling must be 5Kg
weight
Caution
Do not over incline the projector
.
Do not take apart any components of the projector lift.
Do not
take apart
Weight
The maximum weight of installation bracket is 5Kg
底盘的正面需与
投影机的投影方
向一致并平行
Installation
figure 10
figure 11
figure 12
figure 13
Scope of
adjustment: 10mm
figure 14
figure 15
(Figure14)With the projector installed to the installation
base: From the side, insert the joint to the installation
base
(Figure15)Adjust to a desirable angle and direction, then
tighten up the main screw from the bottom.
4