Grandview GPCM-C - Manual

3°
30°
3°
Instruction Manual
GRANDVIEW REPRODUCING GENUINE COLORS
Projector Lift GPCM-C
Applicable Model: GPCM-C Series
Please read before using
Thank you for purchasing our products.
Please read the instruction manual
carefully in order to ensure this projector lift
is suitable for your projection equipment.
Cautious
Warnings
This instruction manual is written for dealers and technicians.
The customer must employ the technicians for installation. Please process the
construction following this instruction manual to avoid injury caused by accidents.
For safety, the minimum load of ceiling must be 40KG
Caution
Please do not incline the
projector the extremely. Please do not take apart the
accessories of projector lift. Do not
take apart
M6-M8 Expanding
Screw or Tapping
Screw
Figure 6 Figure 7
Figure 8
Figure 9 Figure 10
Figure 12 Figure 13
Figure 11
Grandview Crystal Screen Canada Ltd.
#11- 3751 North Fraser Way,
Marine Way Business Centre,
Burnaby, BC, Canada V5J 5G4
Tel: 1-604-412-9777 Fax: 1-604-412-9796
Website: www.grandviewscreen.ca
Guangzhou Grandview Crystal Screen Co., Ltd.
P.O. 511400 Federal Ind. Zone No. 363, Yushan West Road,
Shiqiao, Panyu District, Guangzhou, Guangdong, China
Tel: +8620-8489-9499 Fax: +8620-8480-3343
Website: www.grandviewscreen.com
A. Please install GPC support bar
assembly on the ceiling
Fix the base on the ceiling or concrete
(please ensure that the load is 40kg at least).
Figure 6
Open the back ornament board b, and
loosen the screws of subsidiary arm④
Please adjust the subsidiary arm④ to your
desired position (this function is only for
B200、 B300), and then fasten the screws
again. Please hide the power line into the gap
and close the back ornament board③ b.
Figure 7 and Figure8.
③
.
C. Adjust your desired angle.
Loosen the screws of GPC support bar
assembly⑥
projector to your desired position and fasten
it. Figure 11
via the spanned; adjust the
1.
2. The direction of projector can be adjusted by
forward 30° and backward 3°. Left and
right adjustment is 3°.
Installation for multifunctional arm
(optional accessories)
Install the multifunctional arm on the
projector. Figure 12
Adjust the fixer a of multifunctional arm for
aligning the install hole of low bracket, and
then fasten the screws. Figure 13
Install ornament board⑩b for multifunctional
arm.
⑩
⑩
1.
2.
3.
For installing the completed low bracket to
the top bracket⑦ that push up the completed
low bracket until it is fixed with the security
lock⑨ and fasten the screws,refer to figure9
and figure 10.
Please ensure the GPC projector fixation is
fastened.
Connection of power cord to projector.
Install the back ornament board.
⑧
B.
assembly and GPM projector fixation Please connect the GPC support bar
1.
2.
3.
4.