Grandview GPCQ-X - Manual (Page 2)

3
2
Parts
GPCQ-X
A - Main bar
B - Pillar base
C - M5 x 15 screw (column)
D - Top cap
E - Spring
F - 5x22 cross screw
G - Installation base
H- Extension arms
I - Manual adjustable tightening knob
Accessories:
1/ M6 x 25 anchor screw ( 4 set)
2/ 6 x 50 wood screw (4pcs)
3/ M5 x 8 Philip screw (8 pcs)
4/ M4 x 8 Philip screw (4pcs)
5/ M3 x 8 Philip screw (4pcs)
6/ Hexagon screw (1pc)
7/ Tighening tool
(1pc for installation base and the joint)
8/ Plastic belt
Scope for installation (Installation hole of projector):
Maximum scope for installation:310mm diameter
Minimum scope for installation:40mm diameter
Note: Connect the installation arms to the projector conversely for different installation
holes of projector.
Scope
Maximum diameter: 310mm Minimum diameter: 40mm
The total height of GPCQ-X is 750mm
The main bar (together with the plastic cover) can be cut by user into
desirable height.
Scope
Cable management
(Figure 4, 5) Place the cable into the cable duct on the back, close it
with the the plastic cover.
(Figure 6) Insert in the top cap to the main bar, then fasten with the
added spring.
Installation of the projector
(Figure 7) Position the arms on the installation holes of the
projector. The arms are adjustable from the installation base.
(Figure 8) Please try to position the installation base on the center
of projector.
(Figure 9) Tighten the screws.
figure 1
G
H
I
Fixation on the ceiling
(Figure 1) Locate the desired position of the concrete ceiling, install
the pillar base onto it.
(Figure 2-3) Insert the main bar into the pillar base, then tighten it
up by using M6x25 anchors screws. (Remark: it must be firmly
tightened because it is the main supporting unit.)
1
B
A
B
A
B
Installation
figure 3 figure 2
figure 4
figure 5
figure 6
figure 7
figure 8
figure 9
Installation
B
C
A
E
D
F 5x22 cross screw