Hatteland Display HT C02HI (Compact Entry Level) - Manual (Page 21)

21
IND100210-18
General Installation Recommendations
Installation
Internal Hard Drive (HDD) removal / replacement (Entry Level Models only)
Note: Areas of interest are marked in this section with circles and arrows in RED color. Please disconnect ALL
cables from the computer unit and HDD’s before proceeding!
1: Unscrew 4 screws on each side of the PCI bracket.
Use a Pozidriv #2 screwdriver.
2: Push each side of the bracket, one forward and one
backwards in a 45 degree rotation clockwise to slide it out
of the tracks. Then lift up the the bracket to remove it.
3: Disconnect any cables that are connected to the
HDD’s. Unscrew 4 screws on each side holding the
HDD bracket housing at the bottom of the cabinet.
4: Lift the HDD bracket housing up. Then, depending of
HDD installed or beeing installed, unscrew 4 screws (2
on each side for each HDD) to detach the HDD from the
bracket housing. Use a Pozidriv #2 screwdriver.
Repeat the procedure backwards to finalize operation.