JUGS Sports MVP Baseball (1 wheel) Pitching Machine - Manual (Page 12)

WARNING: To prevent accidental starting or electrical shock that could
cause possible serious injury, assemble all parts to your
machine before connecting it to the power supply. The pitch-
ing machine should never be connected to a power supply
when you are assembling parts, making adjustments, clean-
ing, servicing, or when not in use.
• Carefully lift machine from carton and place on level surface.
• Make sure you have all the parts (See Figure 3). If any parts are missing, do
not operate the machine until the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
• Do not discard the packing materials until you have carefully inspected the
machine, identified all the parts, and satisfactorily operated the machine.
NOTE: If any parts are damaged or missing, do not attempt to plug in the
power cord and turn on switch until the damaged or missing parts are obtained
and are installed correctly.
11
Unpacking
1. Remove T-clamp screw and leg clamp from plastic pack with wheel laying flat
on the ground.
2. Insert T-clamp through the middle of the leg clamp with “claws” of leg clamp on
same side as threads of T-clamp.
3. Screw T-clamp into base of pitching machine two full turns.
4. Holding the leg clamp with one hand, use other hand to insert one leg at a
time into base, making sure you insert legs as far as possible.
5. Tighten T-clamp hand-tight and lift pitching machine up onto legs.
Set Up