JUGS Sports Jr. Baseball & Softball (1 wheel) Pitching Machine - Manual (Page 19)

17
GENERAL OPERATING INSTRUCTIONS
IMPORTANT:
Always position the pitching machine so that two legs are facing the pitching
screen and batter, and one leg is facing back, towards the operator, except as
noted in Figure 14, page 23.
1. Be sure the control switch is in the “OFF” position.
2. Position the dial pointer on the control panel at zero (see Figure 13).
3. Select the correct set of legs for your use (refer to page 14):
a. Use the straight legs for baseball and lacrosse use.
b. Use the curved set of legs (low profile) for softball or field hockey.
4. Select the correct feed chute for your use (see Figure 11).
5. Position the rubber pad bracket until the bolt holes line up with the upper bolt
holes in the rotating plate for softball use, or the lower bolt holes for baseball,
field hockey or lacrosse use (see Figure 12).
6. Connect a 3-wire extension cord (3-prong) into a grounded (3-prong) 110 volt
AC outlet (see Figure 2).
7. Move control switch to “ON” position.
Operation
CAUTION: Never loosen the vertical T-clamp without holding the chute
handle.