JUGS Sports Football Machine - Manual (Page 14)

1. With the tire-side down, place the triangular leg clamp in the leg clamp
casting (see figure 3).
2. Place the lock washer on the threaded end of the Leg T-Clamp,
3. Insert the threaded end of the Leg T-Clamp through the center hole in the
leg-clamp casting and start the threads.
4. Install one leg in each round hole in the center piece of the leg clamp
casting. Tighten the Leg T-Clamp sufficiently to hold the legs in place very
snugly.
5. Place the rubber leg caps on the lower end of the legs if your JUGS
machine is to be used indoors. The leg caps are not recommended for
outdoor use.
6. Lift the football machine upright and onto its legs.
IMPORTANT:
Always set up the machine so that two legs are positioned in front,
facing the target, and one leg facing back toward the operator.
1. Check the speed dial and make sure it is in the full counter-clockwise
position (pointer at the “0” setting) and the toggle switch is in the OFF
position.
2. Plug a heavy-duty, no.16-gauge three-prong, extension cord into a
110-volt GFCI outlet and connect it to the short cord on the pitching
machine.
3. Loosen the Horizontal T-Clamp and position the machine to aim at the
desired target. Re-tighten the T-Clamp. Adjust the desired height of the
machine by using the Elevating T-Clamp. (You will have to practice this
targeting to learn how to set the machine for each pass).
Assembly
12