JUGS Sports Football Machine - Manual (Page 20)

Throwing Footballs End Over End (non spirals)
Use the following to set up JUGS to throw end-over end, to practice kick-off
returns or field goal attempt returns.
1. Remove the nut and bolt on the front of the Passing
Slide assembly (figure 9).
2. Take off the Passing Slide assembly, by removing
the cone-shaped piece (figure 10).
3. Insert the Kicking Slide assembly. Note that the
Kicking Slide assembly has no cone shaped piece
(figure 11).
4. Replace the nut and bolt on the front of the assembly.
5. Tilt the wheels so they are exactly level. The wheels
will be parallel to the ground when you are throwing
end-over-end (figure 12). There are black marker
lines, underneath each tire, to help you line up the
tires so they are exactly parallel to the ground (figure
13).
6. Follow these 5 steps for throwing footballs end-over-
end:
a. Make sure you are using the “kicking” slide.
b. Place the ball onto the slide as shown in figure
14. The ball must be positioned at a 45-degree
angle to get perfect end-over-end tosses.
c. Hold the top of the ball with one hand.
d. Push the slide towards the tires.
e. The ball will travel in an end-over-end fashion
towards your target.
Operation
18
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14