Kent Razo SV17 - Manual (Page 14)

INSTRUCTIONS FOR USE
12
Razor SV17
— 909 6309 000(1)2006-01
BRUSH CLEANING
1. Remove the brush from the machine, according to the
procedure shown in the Use chapter.
2. Clean and wash the brush with water and detergent.
3. Check the brush bristles for integrity and wear; if
necessary, replace the brush.
TANK AND VACUUM GRID CLEANING
1. Drive the machine to the appointed disposal area.
2. Make sure that the switches (5 and 6, Fig. B) are turned
to "0".
3. Lift the cover (1, Fig. J) and apply the cover stand (19,
Fig. J), then clean and wash the cover, the tanks (4 and
5) and the vacuum grid (6) with clean water.
Drain the water from the tanks by means of the drain
hose (16, Fig. C) and valve (18).
4. If necessary, release the retainers (2, Fig. F), open the
vacuum grid (1), remove the float (3), then carefully
clean and reinstall them.
5. Check the cover gasket (7, Fig. F) of the recovery water
tank for integrity.
If necessary, replace the gasket (7) after removing it
from its housing (8).
When reassembling the new gasket, install the joint (9)
in the central area, as shown in the figure.
6. Check the gasket (7, Fig. F) bearing surface (10) for
integrity and sealing capabilities.
7. Check the compensation hole (33, Fig. C) for clogging.
8. Remove the cover stand (19, Fig. J) and close the
recovery water tank cover (1).
SOLUTION FILTER CLEANING
1. Empty the solution tank (5, Fig. J) according to the
procedure shown in the relevant paragraph.
2. Drive the machine on a level ground.
3. Make sure that the switches (5 and 6, Fig. B) are turned
to "0".
4. Remove the transparent cover (1, Fig. G) and the filter
strainer (2); clean and reinstall them on the support (3).
MACHINE SPEED ADJUSTMENT
1. Remove the recovery water tank as shown in the Use
chapter.
2. Adjust the machine speed by means of the screw (13,
Fig. J); according to the following procedure:
–
Loosen the screw (17, Fig. J) on the right side of the
machine, by turning it counter-clockwise;
– Turn the adjusting screw (13, Fig. J)
counter-clockwise to increase the machine speed;
– Turn the adjusting screw (13, Fig. J) clockwise to
decrease the machine speed;
– After adjusting, tighten the screw (17, Fig. J).
3. Install the recovery water tank as shown in the Use
chapter.
4. With the machine ready to operate, carry out hands-on
tests of the machine and, if other adjustments are
necessary, repeat steps 1 to 4.
NOTE
It is advisable to use protective gloves when
cleaning the brush because there may be
cutting debris.
NOTE
The gasket (7, Fig. F) creates vacuum in the
tank, which is necessary for vacuuming the
recovery water.
NOTE
The hole (33, Fig. C) compensates the air in the
cover interspaces, thus allowing the creation
of vacuum in the recovery water tank.
NOTE
Properly install the filter strainer (2, Fig. G) in
the housing (4) of the support (3).
NOTE
The machine speed depends on the floor type
and on the choice of using brush or pad.
The machine speed can be adjusted according
to the following procedure.