Kent Razo SV17 - Manual (Page 6)

INSTRUCTIONS FOR USE
4
Razor SV17
— 909 6309 000(1)2006-01
– Do not leave the machine unattended without being sure
that the machine cannot move independently.
– Do not use the machine on slopes with a gradient
exceeding the specifications.
– Do not wash the machine with direct or pressurized
water jets, or with corrosive substances.
– Do not use the machine in particularly dusty areas.
– While using this machine, take care not to cause
damage to people.
– Do not put any can containing fluids on the machine.
– The storage temperature must be between +32°F and
+104°F (0°C and +40°C).
– The machine operating temperature must be between
+32°F and +104°F (0°C and +40°C).
– The humidity must be between 30% and 95%.
– Always protect the machine against the sun, rain and
bad weather, both under operation and inactivity
condition.
– Do not use the machine as a means of transport.
– Do not allow the brush to operate while the machine is
stationary to avoid damaging the floor.
– In case of fire, possibly use a powder fire extinguisher,
not a water one.
– Do not bump into shelves or scaffoldings, particularly
where there is a risk of falling objects.
– Do not tamper with the machine safety guards and follow
the ordinary maintenance instructions scrupulously.
– Do not remove or modify the plates affixed to the
machine.
– In case of machine malfunctions, ensure that these are
not caused by a lack of maintenance. Otherwise,
request assistance from the authorized personnel or
from an authorized Service Center.
– If parts must be replaced, require ORIGINAL spare parts
from a Dealer or Authorized Retailer.
– To ensure the proper and safe operation of the machine,
have the scheduled maintenance, detailed in the
relevant chapter of this Manual, performed by the
authorized personnel or an authorized Service Center.
– The machine must be disposed of properly, because of
the presence of toxic-harmful materials (batteries, etc.),
which are subject to standards that require disposal in
special centers (see Scrapping chapter).
– If the machine is used according to the instructions, the
vibrations do not cause dangerous situations. The
machine vibration level is less than 98.42 in/s
2
(2.5 m/s
2
)
(98/37/EEC - EN 1033/1995).
– Do not allow any object to enter into the openings. Do
not use the machine if the openings are clogged. Always
keep the openings free from dust, hairs and any other
foreign material which could reduce the air flow.
– This machine cannot be used on roads or public streets.
– Pay attention during the machine transfers when
temperature is below freezing point. The water in the
recovery tank or in the hoses could freeze and seriously
damage the machine.
– Use only brushes and pads supplied with the machine or
specified in this Manual. Using other brushes or pads
could reduce safety.
– When lead (WET) batteries are installed on the machine,
do not tilt the machine more than 30° from the horizontal
plane to prevent the highly corrosive acid from leaking
out of the batteries. If the machine must be tilted to
perform any maintenance operation, remove the
batteries.
UNPACKING
To unpack the machine carefully follow the instructions on the
packing.
When the machine is delivered, check that the packing and
the machine were not damaged during transportation. In case
of visible damages, keep the packing and have it checked by
the Carrier that delivered it. Call the Carrier immediately to fill
in a damage claim.
Please check that the following items have been supplied with
the machine:
1.
Technical documents:
–
Scrubber-dryer Instructions for Use Manual
– Electronic battery charger manual (if equipped).
– Scrubber-dryer Spare Parts List
2. No.1 40A lamellar fuse
3. No.2 battery panels
4. (Only for machine supplied without batteries)
–
No.1 battery jump cable
– No.4 battery terminal caps