Kent Razo SV17 - Manual (Page 7)

INSTRUCTIONS FOR USE
Razor SV17
— 909 6309 000(1)2006-01 5
MACHINE DESCRIPTION
OPERATION CAPABILITIES
This scrubber-dryer is used to clean (scrubbing and drying)
smooth and solid floors, in civil or industrial environment,
under safe operation conditions by a qualified operator.
The scrubber-dryer cannot be used for moquette and carpet
cleaning.
CONVENTIONS
Forward, backward, front, rear, left or right are intended with
reference to the operator’s position, that is to say with the
hands on the handlebar (2, Fig. C).
DESCRIPTION
Control panel
(See Fig. B)
1. Control panel
2. Charged battery warning light (green)
3. Semi-discharged battery warning light (yellow)
4. Discharged battery warning light (red)
5. Brush/pad switch
6. Vacuum switch
Exterior rear view
(See Fig. C)
1. Serial number plate/technical data
2. Handlebar
3. Handlebar inclination adjusting knob
4. Solution flow control lever
5a. Solution flow control lever ECO position (water
"economy" usage, for a washing autonomy of 70-80
minutes).
5b. Maximum solution flow
5.
Recovery water tank cover
6. Rear support wheel for transport/parking
7. Central wheels on fixed axle
8. Brush/pad
9. Brush/pad cover
10. Squeegee
11. Squeegee fixing handwheels
12. Front squeegee blade
13. Rear squeegee blade
14. Squeegee blade fixing springs
15. Recovery water drain hose
16. Recovery water drain hose bracket
17. Solution drain valve
18. Squeegee lifting/lowering lever
19. Solution filter
20. Battery charger-electrical mains connecting cable
(optional)
21. Squeegee vacuum hose
22. Transport/parking device
23a. Transport/parking device activated
23b. Transport/parking device deactivated
23. Transport/parking device positioning pin
24. Electrical component box
25. Battery charger (optional)
26. Battery charger warning lights (optional)
27. Battery installation diagram
28. Battery connector (models without on-board battery
charger)
29. Brush/pad support (activated)
30. Recovery water tank
31. Solution tank
Under-tank front view
(See Fig. J)
1. Recovery water tank cover (open)
2. Recovery water tank cover gasket
3. Brush/pad support (activated)
4. Recovery water tank
5. Solution tank
6. Vacuum grid with automatic shut-off float
7. Recovery water drain hole
8. Vacuum system motor
9. Brush/pad motor
10. Batteries
11. Battery installation diagram
12. Cover with brush/pad-holder coupling pin
13. Machine speed adjusting screw
14. Brush
15. Pad-holder
16. Pad
17. Screw
18. Compensation hole
19. Cover stand (applied)