Kent Razo SV17 - Manual (Page 9)

INSTRUCTIONS FOR USE
Razor SV17
— 909 6309 000(1)2006-01 7
USE
While reading this Manual, the operator must pay particular
attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately
replace them if damaged.
BATTERY CHECK/SETTING ON A NEW
MACHINE
The machine requires two 12V batteries, connected
according to the diagram (28, Fig. C).
The machine can be supplied in one of the following modes:
a) GEL batteries already installed and ready to be
used.
– Start the machine by pressing the brush/pad and
vacuum switches (5 and 6, Fig. B). If the green
warning light (2, Fig. B) turns on, the batteries are
charged.
If the yellow or red warning light (3 or 4, Fig. B) turns
on, it is necessary to charge the batteries before
using the machine (see the procedure in the
Maintenance chapter).
(b) Without battery
– Buy appropriate batteries [See the Technical Data
paragraph and the diagram (28, Fig. C)].
For the battery choice and installation, apply to
qualified battery retailers.
– Perform setting for (WET) or (GEL) batteries, then
install the batteries on the machine and charge them,
according to the procedure shown in the next
paragraph.
(WET OR GEL) BATTERY SETTING,
INSTALLATION AND CHARGING
The electronic board of the machine is to be set according to
the type of batteries chosen, lead (WET) or gel (GEL).
Proceed as follows:
Machine setting
1. Ensure that the battery connector (29, Fig. C), if
equipped, is disconnected.
2. The machine factory setting is for GEL batteries; if
this setting corresponds to the type of batteries bought,
go to step 6. Otherwise, carry out steps 3, 4 and 5 too.
3. Remove the screws (5, Fig. I) and carefully pull out the
electrical component box cover (1).
4. Turn the microswitch (6, Fig. I) to WET position.
5. Reinstall the electrical component box cover (1, Fig. I)
and tighten the screws (5).
Battery installation
6. Disconnect the vacuum hose (22, Fig. C) from the
squeegee (11).
7. Disconnect the recovery water drain hose (16, Fig. C)
from the bracket (17).
8. Open the cover (6, Fig. C) and apply the cover stand (19,
Fig. J).
9. Grasp the recovery water tank (1, Fig. H) in the area (2)
and slightly raise it.
10. Disconnect the vacuum hose (3) from the tank, then
remove the tank (1) with the hoses (4) and (5).
11. Install the batteries on the machine according to the
diagram (28, Fig. C).
12. Reinstall the tank (1, Fig. H) by carrying out steps 6 to 10
in the reverse order.
Battery charging
13. Charge the batteries (see the relevant procedure in the
Maintenance chapter).
WARNING!
On some points of the machine there are some
adhesive plates indicating:
–
DANGER
– WARNING
– CAUTION
– NOTE
WARNING!
The electric components of this machine can
be seriously damaged if batteries are either
installed or connected improperly. The
batteries must be installed by qualified
personnel only.
Check the batteries for damage before
installation.
Handle the batteries with great care.
Install the battery terminal caps supplied with
the machine.
WARNING!
Do not move the adjacent switch (7, Fig. I).