Lab.gruppen D Series 80:4L - Manual (Page 25)

14. Faults and warnings
D SERIES Lake Quick Start Guide rev 1.2.0
25
Category/Type Name On screen text Description Action
Warning More speakers OVR SPKR COUNT
LoadSmart detected more speakers
than expected
Check load and
cabling or fingerprint
Warning Uncertain about load UNCERTAIN LOAD LoadSmart uncertain about load
Check load and
cabling or fingerprint
Warning Load not verified LOAD NOT VER LoadSmart not verified
Perform LoadSmart
verification
Fault No load NO LOAD
At leats one LoadPilot tone above
measurable area or significantly
above thresholds
Check load or calibration
Fault Wrong load WRONG LOAD
LoadSmart detected impedance
response output model
Check load and
cabling or fingerprint
Fault Short circuit SHORT CIRCUIT
LoadPilot or full frequency analysis
below short threshold or hardware
short protection
Check load and cabling
AMP
Warning
Temp warning amplifier
channel
TEMP WARN
Amplifier channel is approaching
critical temperature
Improve cooling or reduce
output power to avoid
temperature becoming
critical
Fault Temp Fault amplifier channel TEMP FAULT
Amplifier channel has reached
internal protection limit
Automatically unmutes
when cooled down
Fault Service channel SERVICE CH. Amplifier channel is damaged
Restart device; if not
cleared it needs service
Fault Very high frequency fault VHF FAULT Amplifier channel protection Check input signal
Clip Current average limiter CAL ACTIVE
Average current on amplifier
above safe operating level
Reduce output power
to avoid limiting
Clip Current clip CURRENT CLIP
Amplifier channel reached
current limit
Reduce output power
to avoid limiting
Clip Voltage clip VOLTAGE CLIP Amplifier reached voltage limit
Reduce output power
to avoid limiting
Clip Module clip MOD. CLIP Module output signal clipped
Review gain structure.
Module gain vs AmpGain
SIGNAL
Fault No input source NO INPUT
Input router has no valid
input source
Review input router
settings/connections
Clip Analog/AES input clip INPUT CLIP
The signal on the analog/AES input
is above inputs capability
Lower the signal on the
feed to the amplifier