Labconco Biological Safety Cabinets 34610 Series - Manual (Page 15)

Chapter 3: Getting Started
Product Service 1-800-522-7658 10
2. Select the height of the stand and slide four (4) leg extensions into base
stand corner posts and attach with 2 ¼ inch long bolt, flatwasher,
lockwasher and nut. Ensure that the same height hole is selected for each
leg. Tighten the leg bolts securely. See Figure 3-1.
3. CAUTION: Only lift and support the weight of the cabinet at the
stainless steel sides and back. Damage will occur if lifted or supported on
the front edge. Move the base stand into its final location. Using a
carpenter’s level, adjust each leveling foot until the stand is level in both
planes as shown in Figure 3-2. You are now ready to lift the Biosafety
Cabinet onto its stand.
Figure 3-2
Figure 3-1