Labconco CAptureTMPortable Fuming System 3420024 - Manual (Page 17)

Chapter 4: Using the System
Product Service 1-800-522-7658 13
2. Select the hooks or shelves
needed to hang or support the
evidence to be developed. Engage
the hooks and/or shelves into the
appropriate holes on the stainless
steel face plate, as shown in
figure 4-5.
3. Place the evidence so that fumes
can contact as much of its surface
as possible. If desired, place a
control fingerprint on a glass
slide, and set the slide into one of
the slide slots in the face plate.
4. Seal the clear chamber to the stainless face plate, using the clamps on
either side of the chamber. The unit is now in operating mode, as
shown in Figure 4-2a and 4-2b.
5. Plug the unit in, and make sure the main power switch is in the “ON”
position.
Figure 4-5