Labconco FreeZone User Manual
Page 5
Page 4 of 5
Vacuum Pump
Receptacle
Upper Back
Panel
Chamber Lid
o
Place the vacuum pump inside the
cabinet.
o
Connect the vacuum hose to the inlet
fitting of the vacuum pump. Clamp
securely.
o
Reinstall the front panel by positioning the top edge
under the control panel and pushing the bottom
inward.
o
CAUTION - Make sure that power to the
Freeze Dryer is disconnected before
removing the lower back panel. Do NOT
remove the upper back panel.
o
Plug the vacuum pump power cord into the
receptacle in the junction box marked
Vacuum Pump.
o
Replace the rear panel.
Step 5. Installing a Chamber or Manifold (except
4.5L models which have chamber already attached)
• 1L and 2.5L Models
o
Place the collector chamber lid on top of the
chamber.
o
Center the flat rubber gasket on the hole in the
center of the chamber lid.
o
Place the chamber or manifold over the gasket.
o
If installing chamber, insert plastic fitting
(7386901) through hole in the chamber and
through hole in the gasket.
(7386901)