Labconco PrimeMate Oil Change System 73570 Series - Manual (Page 8)

Chapter 2: Prerequisites
Product Service 1-800-522-7658 4
Electrical Requirements
The PrimeMate Oil Change System operates on 12 VDC. A power supply is
provided which must plug into a wall receptacle. Minimum requirements for
an outlet is a 15 Amp circuit breaker or fuse for models rated at 115V (60
Hz) or an 8 Amp circuit breaker or fuse is required for 230V (50/60 Hz)
models. 115V models for use in North America are equipped with a 15 Amp
NEMA 5-15P plug. 230V models are available with a NEMA 6-15P plug for
use in the United States, a PS 1363 plug for use in the United Kingdom, a
CEE 7/7 plug for use in Europe or a CHI-10P plug for use in China. It may
be necessary to remove the plug and install a different plug to match the
available receptacle if one of these models does not meet your needs.
Location Requirements
The PrimeMate Oil Change System includes a hose that is 6 feet long;
therefore, it must be located within 6 feet from the vacuum pump to which it
will be connected.
Space Requirements
Refer to Appendix B: PrimeMate Oil Change System Dimensions for
dimensional drawings of the PrimeMate Oil Change System.
Tools Required
Common hand tools are required to set up the PrimeMate Oil Change
System. A 19 mm open end wrench or an adjustable wrench is required to
attach the coupling body to the vacuum pump.