Labconco Protector Multi-Hazard Glove Box 5065502 - Manual (Page 7)

INTRODUCTION
8
Component Identification
General components of the glove box are listed below and identified in Figure 2.
1. Glove Ports. Epoxy coated aluminum, 8" ID, spaced 17" apart, sealed to viewing window
with one-piece molded neoprene gasket. Supplied with dual O-ring grooves, neoprene
gloves, and retaining O-rings.
2. Neoprene Gloves. Supplied with the glove box, gloves are .015" thick neoprene, 30" long,
one pair, and size 9-3/4. (Note: For replacement gloves, see Replacement Parts on page
18.
3. Window Frame. 12-gauge epoxy coated steel, attached with 30 stainless steel, ¼-20
screws, removable for full access to the interior.
4. Viewing Window. 3/8" thick laminated safety glass, mounted at 10° angle and sealed with
one-piece molded neoprene gasket. Optional 3/8" thick polycarbonate with abrasion
resistant coating available. See page 18.
5. Left Side Panel. 20-gauge epoxy coated steel, easily removable for access to glove box
and left electrical outlet.
6. Fluorescent Lamp. 30 watts provides minimum of 60-foot candles illumination to interior
work surface. Supplied with electrical cord and plug, the lamp may be easily removed for
bulb replacement and for access to removable viewing window. For lamp replacement see
page 16.
7. Façade. 18-gauge, epoxy coated steel, conceals filter damper, and blower.
8. Control Panel. Contains gauge for glove box pressure and switches for fluorescent lamp,
interior receptacles, blower power, and blower speed control.
9. 115 Volt, 3-Wire Receptacles (Models 5065000 and 5065500). One right and one left
interior receptacle, 9 amps combined rating. Exterior switches provide separate control of
each receptacle.
230 Volt, 3-Wire Receptacles (Models 5065002 and 5065502). One right and one left
interior receptacle, 8 amps combined rating. Exterior switches provide separate control of
each receptacle.
10. Transfer Chamber Door. Counterweighted with quick operating latch.