Laerdal SimJunior Standard - Manual (Page 19)

17
Manikin Setup
Draining Excess IV Fluid
The IV fluid system is an open system. IV fluids are drained as they
are administered.
Before each session:
1. Attach the IV overflow tube (in the manikin’s right arm) to an
overflow container (such as an IV bag).
2. Allow excess fluid to drain into a container during the
simulation..
Cleaning the IV Arm
Clean the IV arm after each session or day of use by flushing the IV
Arm with 60% isopropanol or 70% ethanol.
Installing Defibrillation Adapter Plates
The manikin torso is fitted with two stud connectors for defibrillator
cables. Before attempting defibrillation, you must unscrew and remove
the defibrillator stud covers.
Two defibrillation adapter plates are packaged with the manikin. The
defibrillator adapter plates must be fitted in place before using a live
defibrillator with defibrillation paddles or adhesive pads. Screw the
adapter plates firmly into place.
During Defibrillation
A conventional defibrillator (not included) may be used on the
SimJunior. During live defibrillation, the defibrillator and manikin may
present a shock hazard. All standard safety precautions must be taken
when using the defibrillator on the manikin.
Caution: The manikin must not be in contact with electrically
conductive surfaces or objects during defibrillation.
Warnings:
– Defibrillation must be performed on the defibrillator connectors
only.
– Do not press too hard over the defibrillation adapters as this may
cause arcing and pitting.
– Do not defibrillate the manikin without the torso skin in place.
Connecting the Blood Pressure Cuff
The manikin is delivered with a customized blood pressure cuff.
Connect the tube to the white BP connector on back of the Link Box
before use.
Note: The speaker for the Manikin’s blood pressure is located
in the left antecubital fossa, shown below circled. The radial
and brachial pulses are located in the rectangular areas.
Calibrating the Blood Pressure Cuff with Instructor PC
1. Select <Calibration> from the menu.
2. Select <Calibrate BP...> from the drop-down menu.
3. Follow the on screen wizard instructions to perform the
calibration.
Intr
oduction
Standar
d System
Advanced System
Manikin Setup
Maintenance
Spar
e Par
ts
Tr
oubleshooting
Specifications