Laerdal Ultimate Hurt - Manual (Page 6)

To Remove:
1. Pull plate out by applying pressure to center of plate.
2. Work your fingers under edge of plate.
3. Lift out.
To Insert:
1. Position plate over cavity.
2. Work edges into groove on torso cavity.
Injection Pads:
To remove:
Squeeze pad together with fingers and pull.
To replace, reverse procedure.
Waist, Elbow, Knee and Ankle Joints:
These joints are connected by a bolt and lock nut.
Laerdal 6
To remove:
1. Unscrew lock nut.
2. Pull bolt out of joint.
The segments will now easily
disconnect.
Arms:
Arms are attached with a bolt, two washers, a spring and a
wing nut.
To attach:
1. Remove chest plate from manikin to locate hole in
shoulder.
2. Remove deltoid injection pad from arm.
3. Unscrew wing nut from bolt in arm and remove wing
nut, two washers and spring.
4. Insert bolt through hole in shoulder.
5. Slide one washer, spring and second washer back over
bolt.
6. Use a screwdriver to hold bolt steady while tightening
the wing nut. (See Fig. 1)
To remove arms, reverse procedure.
Fig. 1
201-00001
Laerdal Recommends:
When assembled, dust with
talcum powder to enhance
articulation.