Laerdal Ultimate Hurt - Manual (Page 8)

IMPORTANT: MR HURT HEAD IS NOT
AN INTUBATION TRAINER!
Care and Maintenance:
1. Clean with mild soap and water; do not submerse
manikin or parts in cleaning fluids or water.
2. Use only on clean surface. Avoid felt tipped markers, ink
pens, acetone, iodine or other staining products and
avoid placing the manikin on newsprint or inked lines of
any kind.
3. To ensure longevity, each manikin should be cleaned
after each training session and a general inspection
should be conducted regularly.
4. Modules and all other parts should be drained and air
dried thoroughly before storage and disinfected when
needed. After use of injection pads (use water only),
accumulated water should be squeezed out. Do not
store wet foam pads in the skin. To prevent mildew or
mold, pads can be soaked in a mild solution of
disinfectant and water or bleach and water. Squeeze
excess solution from pads, allow them to dry, then store
or reinsert in manikin.
5. Articulating parts will benefit from a light application of
talcum powder prior to training sessions.
6. Store properly between teaching sessions.
Cautions and Warnings
This product contains Natural Rubber latex which may
cause allergic reactions when in contact with humans.
201-00001 Laerdal 8