LINK Systems LinkNet I - Manual (Page 44)

LinkNet
A.4
manual rev 2.1 March 25, 1999
Figure A.5: OIT to New Communications
Board Connections
A.3.2 OmniLink OIT Software Upgrade
Procedure
@
Review the chip changing rules in section A.1.
@
Remove power from the OmniLink card rack
and
the OIT.
@
Remove the screws from the back panel of the
OIT, and remove the back panel.
@
Using Figure A.6, locate and remove chips
5000-C, 5000-D, and 5000-E.
@
Insert the new 5000-C, 5000-D, and 5000-E
chips.
@
Install the back panel on the Operator Terminal.
Figure A.6: OIT Circuit Board