LINK Systems LinkNet I - Manual (Page 47)

LinkNet
A.7
manual rev 2.1 March 25, 1999
A.3.7 OmniLink Auto-Setup Module Software
Upgrade Procedure
This upgrade procedure applies only if the
OmniLink control has an extended card rack and has
the auto-setup module installed.
@
Review the chip changing rules of section A.1.
@
Remove power from the OmniLink card rack
and
the OIT.
@
Remove the Auto-Setup board from the card
rack.
@
Remove the module (if present) installed in the
SS1 position.
@
Using Figure A.11, locate and remove the 5000-
10 chip.
Figure A.11: OmniLink 5000 Auto-Setup
Module Circuit Board.
@
Insert the new 5000-10 chip.
@
If a module was removed from SS1, replace it.
@
Insert the Auto-Setup Module in the card rack.