LINK Systems OmniLink - PLC Interface User Manual
Page 23
June 5, 2000
Man ual Rev 1 .0
3.9
Figure 3.6:
Example PLC Softkey Configuration Screen
NOTE:
PLC Screen Status Labels are not a required part of the PLC Interface. If status/error
messages are not going to be sent from the PLC to the OmniLink display, then this
section may be skipped.
Each PLC action key (“PLC Softkey 2" through “PLC Softkey 6") can be enabled or disabled by
selecting “Yes” or “No” for the “Used” parameter. Softkeys that are not used will not be displayed on
the PLC operation screen. See Figure 4.1 to see how these keys would look on the PLC operation
screen.
Section 3.6
Screen Status Label Configuration
Each PLC screen may have up to 4 lines of “screen status”. Each line may have its’ own label or
“legend”. Figure 3.7 shows an example Status Label Configuration screen.