Mossberg 935 Magnu - Manual (Page 15)

13
TRIGGER HOUSING ASSEMBLY REMOVAL
1. Push out the two trigger housing retaining pins using a blunt object no
larger than 1/8" diameter (Figure 12). (The pins can be pushed out from
either direction).
2. Remove the trigger housing assembly by pulling it straight out of the
receiver.
The trigger housing assembly is a complex assembly and must not be
disassembled. Disassembly should only be performed at an authorized
Product Service Center or by a qualified gunsmith.
Do not pull the trigger and allow the hammer to fall when the trigger
housing assembly is removed from the receiver. To do so may result in
personal injury or damage to the assembly.
Field disassembly is now complete. The firearm should not be disassembled
any further for routine cleaning or maintenance. Further disassembly should
only be performed at an authorized Product Service Center or by a qualified
gunsmith.
Figure 12
122276 1/19/12 2:37 PM Page 13