Mossberg 935 Magnu - Manual (Page 8)

6
TO INSTALL THE MAGAZINE PLUG
Be sure the firearm is unloaded by visually and physically checking
the chamber, elevator, and magazine tube. Make certain that the safety but-
ton is fully rearward in the “ON” (SAFE) position before performing any
assembly or disassembly procedure.
Unscrew and remove the magazine cap (Figure 9), insert either end of the wooden
dowel at the end of the magazine tube, inside the coils of the magazine spring.
Replace the magazine cap finger tight only. Do not use pliers or a wrench to
tighten the magazine cap.
MAGAZINE CAPACITY
930
TM Models: Five (5) 2 3/4" or 3" cartridges (four (4) in the magazine tube, plus
one (1) in the chamber).
930 SPX:
Eight (8) 2 3/4" cartridges (seven (7) in the magazine tube, plus
one (1) in the chamber), or seven (7) 3" cartridges (six (6) in the
magazine tube plus one (1) in the chamber).
935 TM Models: Five (5) 2 3/4" or 3" cartridges (four (4) in the magazine tube, plus
one (1) in the chamber), or four (4) 3 1/2" cartridges (three (3) in the
magazine tube, plus one (1) in the chamber).
MAGAZINE PLUG – You are responsible for complying with all laws regarding
magazine capacity. To comply with U.S. migratory bird laws, your firearm was
shipped with a wooden dowel inserted into the magazine tube which limits
magazine capacity to two (2) shells. (930 SPX models do not include the
wooden dowel)
TO LOAD THE FIREARM
930
TM Models: are designed to fire 12 gauge 2 3/4" factory loaded cartridges and
3" factory loaded magnum cartridges.
935 TM Models: are designed to fire 12 gauge 2 3/4" (1 1/4 oz Heavy Field minimum),
3" or 3 1/2" factory loaded cartridges only. Do not fire slugs of any type (single
projectile ammunition) through the overbored
935 TM Accu-Mag barrel. This barrel is
designed to shoot lead or steel pellet shot only. Use only
935 TM barrels designated
specifically for slug shooting.
Fully rifled barrels deliver best accuracy with sabot style slugs. “Rifled” slugs and
shot are not recommended for use in rifled barrels.
Before loading, move the safety button fully rearward to the “ON” (SAFE)
position (Figure 1).
During loading, never allow fingers or any other objects to contact the
trigger. Keep the muzzle pointed in a safe direction at all times.
(Excluding SPX)
122276 1/26/12 3:00 PM Page 6