Mossberg 935 Magnu - Manual (Page 18)

16
Figure 13
TRIGGER HOUSING ASSEMBLY RE-ASSEMBLY
1. Insert the trigger housing assembly into the receiver and align the two
trigger housing retaining pin holes (Figure 14).
2. Push in the trigger housing pins until they are flush with the sides of the
receiver.
Figure 14
5. To install the operating handle, first ensure the safety button is fully
rearward in the “ON” (SAFE) position. Next, hold the operating handle with
the notch facing rearward and push the handle through the bolt into the
slide assembly. Push the operating handle inward until the plunger engages
with the notch in the operating handle. Gently tug outward on the operating
handle to ensure it is securely engaged in the bolt. The operating handle will
now prevent the action from coming out of the receiver.
122276 1/19/12 2:37 PM Page 16