Dell PowerVault 3000i - Manual (Page 43)

Setting Up Your iSCSI Storage Array
43
4 Edit the following entries in the /etc/iscsi/iscsid.conf file:
a Edit (or verify) that the node.startup = manual line is disabled.
b Edit (or verify) that the node.startup = automatic line is enabled. This will enable
automatic startup of the service at boot time.
c Verify that the following time-out value is set to 144:
node.session.timeo.replacement_timeout = 144
d Save and close the /etc/iscsi/iscsid.conf file.
5 From the console, restart the iSCSI service with the following command:
service iscsi start
6 Verify that the iSCSI service is running during boot using the following command from the console:
chkconfig iscsi on
7 To display the available iscsi targets at the specified IP address, use the following command:
iscsiadm –m discovery –t st -p < IP_address_of_iSCSI_port >
8 After target discovery, use the following command to manually login:
iscsiadm -m node –l
This logon will be performed automatically at startup if automatic startup is enabled.
9 Manually log out of the session using the following command:
iscsiadm -m node -T <initiator_username> -p <target_ip> -u