If you are using sles10 sp1 via the gui – Dell PowerVault 3000i User Manual
Page 53
Setting Up Your iSCSI Storage Array
53
discovery.sendtargets.auth.password = password_1
discovery.sendtargets.auth.username = iqn.1984-
05.com.dell:powervault.123456
discovery.sendtargets.auth.password_in = test1234567890
If you are using SLES10 SP1 via the GUI
1 Select Desktop→ YaST→ iSCSI Initiator.
2 Click Service Start, then select When Booting.
3 Select Discovered Targets, then select Discovery.
4 Enter the IP address of the port.
5 Click Next.
6 Select any target that is not logged in and click Log in.
7 Choose one:
•
If you are not using CHAP authentication, select No Authentication. Proceed to step 8.
or
•
If you are using CHAP authentication, enter the CHAP username and password. To enable
Mutual CHAP, select and enter the Mutual CHAP username and password.
8 Repeat step 7 for each target until at least one connection is logged in for each controller.
9 Go to Connected Targets.
10 Verify that the targets are connected and show a status of true
.