Desa FDCFTN - Manual (Page 11)

111244-01A
For more information, visit www.desatech.com For more information, visit www.desatech.com
11
11
O
F
F P IL O T O N
H I L O
Figure 12 - Attaching Brass Trim to Fireplace
Shoulder Screw
Assembled
Brass Trim
Hole for 3" Wood Screw for
Attaching Fireplace to
Wooden Base
Hole for 3"
Wood Screw
for Attaching
Fireplace to
Mantel
Shoulder
Screws
13. Check for leaks. See Checking Gas Connections, page 16.
14. Place mantel around fireplace. Be careful not to damage wall
or mantel.
15. Place perimeter trim kit on the shoulder screws located on the
side and top of the fireplace. Firmly snap trim over shoulder
screws on fireplace (see Figure 12).
16. Adjust assembly to remove any gaps. Attach remaining two 3"
wood screws from hardware pack through openings inside of
fireplace sides into the mantel. The openings are located at top
behind the area for top louver (see Figure 12).
17. Reinstall top louver.
INSTALLATION
Continued
Gas Line
Access Hole
Mantel
Base
Assembling Perimeter Trim (Perimeter trim shipped
with mantel)
1. Remove packaging from three remaining pieces of trim.
2. Locate two adjusting plates with set screws, and two shims
in the hardware packet.
3. Align shim under adjusting plate as shown in Figure 13.
4. Slide one end of adjusting plate/shim in slot on mitered edge
of top brass trim (see Figure 13).
5. Slide other end of adjusting plate/shim in slot on mitered edge
of side perimeter trim (see Figure 13).
6. While firmly holding edges of perimeter trim together, tighten
both set screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
8. Set perimeter trim assembly aside for later installation.
Figure 13 - Assembling Brass Trim
Side Brass Trim
Top Brass Trim
Mitered Edge
Shim
Set
Screws
Adjusting
Plate
Slot
INSTALLING OPTIONAL BLOWER ACCESSORY
GA3450TA
Removing Upper Louver
To install the blower accessory, you must first remove the upper
louver.
1. Lift screen off fireplace and remove log set if installed.
2. Remove 4 screws from upper louver (see Figure 11, page 10).
Save these screws.
3. Pull upper louver straight out from the cabinet. Be careful not to
scratch the paint. Set louver aside.
4. Open lower louver door by swinging door down (see Figure 11,
page 10).
INSTALLATION
Optional Mantel Installation (Cont.)
Installing Optioanl Blower Accessory GA3450TA