Vented gas logs, Installation, Continued – Desa VVDA24R User Manual

Page 10: Propane/lp gas conversion

Advertising
background image

®

10

901272

VENTED GAS LOGS

INSTALLATION

Continued

Propane/LP Gas Conversion

To convert to propane/LP gas, the regulator
pressure must be reset. Also, the burner inlet
fitting and pilot orifice must be replaced. The
propane/LP burner inlet fitting is supplied
with the orifice installed for your log set.

Burner Inlet Fitting

1.

Remove the burner inlet fitting from the
gas control assembly (see Figure 14).
DO NOT remove the orifice from this
fitting. The propane/LP burner inlet fit-
ting is included in the hardware kit (see
Figure 15).

2.

Be sure to use the correct orifice for your
appliance. The orifice kit included with
this appliance contains an orifice in-
stalled in an air mixer fitting.

3.

Using thread sealant (resistant to the
action of propane/LP gas) on smaller
end of fitting, screw the burner inlet fit-
ting into the outlet side of the gas con-
trol. Tighten using a wrench.

4 . Follow steps 1 through 14 under Kit As-

sembly, pages 9 and 10.

Figure 15 - Burner Inlet Fittings with
Injectors

NATURAL

GAS

FITTING

PROPANE/

LP GAS

FITTING

Injector for
Natural Gas
(Factory
Installed)

Injector for
Propane/LP
Gas (Factory
Installed)

Figure 14 - Remove Burner Inlet Fitting

Burner Inlet
Fitting for
Natural Gas

O

F
F

P

ILO

T

O

N

O

F

F

P

ILO

T

O

N

Piezo Ignitor

Screw

Valve
Cover

Figure 13 - Installing Thermocouple, Pi-
lot, and Piezo Ignitor Cover

Thermocouple

Ignitor

Pilot

Piezo Ignitor
Cover

Machine
Screw

13. Install cover to burner pan using screws

provided.

14. Install thermocouple, pilot, and piezo ig-

nitor cover onto valve cover as shown
in Figure 13. Use the provided screws.

Figure 16 - Removing Pressure Button

Adjusting Regulator Pressure For
Propane/LP Conversion

1.

Locate the pressure button on regula-
tor tower of gas control valve.

2.

Remove the pressure button from the
regulator tower (see Figure 16).

3.

Reverse the pressure button and replace
into regulator tower (see Figure 17).

Figure 17 - Replacing the Pressure But-
ton in the Propane/LP position

O

F

F

P

ILO

T

O

N

Regulator Tower

Pressure
Button

Gas Control Valve

O

F

F

P

ILO

T

O

N

Regulator Tower

Pressure
Button

Gas Control Valve

Advertising
This manual is related to the following products: