Pitney Bowes DM575 Series - Manual (Page 160)

9 • Maintaining and Updating
9 - 6 SV62201 Rev. C
Cleaning or
Replacing the
Moistener Brush 1. Lift the feed cover.
2. Push down on the moistener brush button.
3. Grasp the moistener brush assembly and pull it straight out towards
you.
4. Clean the moistening brush by running the brush under warm water.
5. If you need to clean or replace the wick, go to Cleaning or Replacing
the Wick procedure below. Otherwise go to step 6.
6. Replace the existing clean moistener brush assembly, or install a new
one by pushing the assembly back on its track until it snaps into posi-
tion.
7. Check to make sure that the flap blade of the moistener brush assem-
bly is under (and not over) the stripper finger as shown here.
8. Verify that the moistener brush assembly is perfectly level with the feed
deck.
Moistener brush button
Moistener brush assembly
Flap Blade
Stripper Finger
Feed Deck Moistener Brush Assembly