Pitney Bowes DM575 Series - Manual (Page 165)

DM525™ and DM575™ Series Digital Mailing System Operating Guide
SV62201 Rev. C 9 - 11
c. If the tank is still not
filled to the correct
level, remove the moist-
ener tank and drain it
over the front of the
machine, then replace
the tank and check the
level again after 5 min-
utes.
14. Once you verify that the
moistener tank is filled to
the correct level with E-Z
Seal® Solution, gently push
the tank all the way back to
its original position.
Replace the moist-
ener brush assembly
by pushing it back on
its track until it snaps
into position.
Check to make sure
that the flap blade of
the moistener brush
assembly is under
(and not over) the
stripper finger as
shown here.
15. Verify that the moist-
ener brush assembly
is perfectly level with
the feed deck.
16. Close the feed cover.
17.
Printer

Maintenance
The printer components, consisting of the printer nozzle, ink cartridge and
printhead, require minimum maintenance to ensure clean, clear meter
imprints on your mail.
If the print quality deteriorates and you cannot improve it with the proce-
dures in this chapter, contact the Pitney Bowes Help Desk. Refer to the

Pitney Bowes Contact Information List at the front of this guide for the
phone number.
Stripper

finger
Flap

Blade
Feed

deck
Moistener Brush
Assembly