Raloy IP Functions for KVM - Manual (Page 5)

2
2. Setup Fixed IP
c. Setup “IP auto configuration” as “ None” ; setup IP address and Subnet mask
d. Enter Super user login and password for Authentication (default : super/pass)
e. Click Setup Device. If super login was authenticated, it’ll show “Successfully configured device”.
Otherwise it’ll show “Permission Denied”.
Authentication
To adjust the authentication settings, enter your login as a super user, and change your password.
Super user login
Enter the login name of the super user. The initial value is “super”. All characters
are in lower case.
Super user password
Enter the current password for the super user. This initial value is “pass”. All
characters are in lower case.
New super user password
Enter the new password for the super user.
New password (confirm)
Re-type the new password for the super user for confirmation.
To close the window and accept the changes, press the “OK” button; otherwise
press the “Cancel” button.
1-1.1 Setup Fixed IP
For using serial terminal, the IP module has a serial line interface (host side). This
connector is compliant with the RS-232 serial line standard. The serial line has to be
configured with the parameters given in the table below.
When configuring with a serial terminal, e.g., Hyper Terminal, reset the IP module and
immediately press the “ESC” key. You will see some device information, and a “=>”