Rocktron Piranha - Manual (Page 20)

17
ΠConnect a standard MIDI cable from the MIDI IN of the receiving Piranha
to the MIDI OUT on the transmitting sequencer.
Note: Do not allow connection from the MIDI IN of the transmitting sequencer back to
the MIDI OUT of the receiving Piranha.
C. MIDI Preset Load
The Piranha presets can be loaded from a sequencer via system exclusive messages.
 Send the real-time sysx track from the sequencer or data storage device. The
STORE button on the Piranha will blink to indicate that the dump is in progress.
If the dump is accepted, the Piranha will display "1".
If an error occurs during transmission, the Piranha will display "E0". If this
occurs, try dumping the data again. If errors still occur, the data being dumped
may be corrupted.
Note: When receiving a bulk load, it is important that the data loaded to the Piranha is
not transmitted faster than it was originally dumped from the Piranha. If infor-
mation is sent to the Piranha too fast, an error will occur.
When dumping information from a data storage device, it is necessary to perform
the dump in sequence mode rather than sysx mode. Sequence mode will dump the
information back to the Piranha at the same speed that it was received from the
Piranha.