Rocktron Piranha - Manual (Page 21)

18
D. Continuous Controller Mode
When set to operate in Continuous Controller mode, the Piranha's front panel controls can be used to control other
MIDI products in real time. To use the Continuous Controller mode, set the parameter(s) on the receiving unit(s) to
respond to the controller number for the given Piranha front panel knob (shown below). For example, if the Reverb Level
parameter on a Rocktron Intellifex was set to respond to controller 18, the front panel BASS control on the Piranha could
be used to adjust that Intellifex parameter.
ΠWhile holding the HUSH button, press the GLOBAL button to initiate the
Continuous Controller mode. The front panel GLOBAL and STORE LEDs will
blink to indicate that Continuous Controller mode is currently active.
Note: Continuous Controller mode can also be accessed by sending the Piranha
controller number 50.
* * * * To cancel the Continuous Controller mode, press the GLOBAL button twice. * * * *
Note: Program changes can not occur when operating in Continuous Controller
mode.
The front panel knobs transmit the following controller numbers and value ranges: