Speck Electronics Xtramix - Manual (Page 36)

This section allows an external stereo auxiliary source such as a DAT
recorder, CD player/recorder or any stereo audio signal to be routed to
the Monitor and/or Headphone outputs of the Xtramix.
The Stereo Aux Return Section includes the return level control, and the
return mute switch. The Aux Return may be operated in mono when a
single signal is plugged into the left input jack.
This dual potentiometer controls the level of an external stereo aux
source and returns only to the Monitor and/or the Headphone outputs.
This switch allows the Muting of the Aux Return. Enabling this switch
removes the stereo aux return signal from the Monitor and Headphone
outputs.
The talkback section of the Xtramix incorporates an internal omni-
directional microphone. This sensitive microphone will operate most
efficiently when the operator speaks at a distance of about two feet from
the mike. This mike is activated by the Talkback Switch and is adjusted
with the Talkback Trim Control.
This momentary switch activates the talkback circuit and permits the
operator to talk or slate to the stereo master outputs.
When the Monitor Configuration Switch on the rear panel is set to the
"pre" position, it is possible to talk or slate only to the program master
outputs. When the Monitor Configuration Switch is set to the "post"
position, the talk signal also appears on the monitor outputs.
This control adjusts the volume of the talkback circuit to the program
output. The suggested setting for this control is approximately the two
o'clock range and adjust as necessary.
Stereo Aux
Return Section
44. Aux Return Level Control
45. Aux Return Mute Switch
31
46. Talkback Mic
47. Talkback Switch
48. Talkback Trim Control
Talkback Section
Chapter 4 Operation Section