SpectraCal VideoForge 4K - Manual (Page 5)

17544 Midvale Ave. N. Shoreline, WA 98133 USA
Corporate: +1 206 420 7514 | Tech Support: +1 206 457 8949 | www.spectracal.com
VideoForge 4K
CalMAN Setup Guide
The AVFoundry VideoForge Digital Video Generator can be automatically controlled by the
CalMAN Display Calibration Software.
Recommended CalMAN Workflows:

All available measurement and calibration workflows
Required VideoForge Firmware:

All firmware versions are acceptable
VideoForge Control Connection:

Ethernet LAN cable (straight-through or crossover cable)
CalMAN Connection Procedure
To connect CalMAN 5 to the VideoForge for automatic CalMAN control:
1. Connect the VideoForge to a network router or directly to the CalMAN computer, power
on the VideoForge, and note the unit’s IP address on the LCD.
2. On the CalMAN Source Settings tab/click “Find Source,” then select “AV Foundry;
VideoForge II.”
3. Enter the VideoForge IP Address.
4. Click Connect on the Source connect dialog.
CalMAN Source Settings Tab
Triplet Support
The VideoForge provides full RGB triplet support to provide test patterns that are
compatible with 3D cube LUT calibration.